Equipment name: On-line car plastic parts automatic foam sticking machine

Model: ATM-FHM1

Equipment introduction: Back glue is supplied by coil material, which is fed by Feida; sponge is fed by vibrating plate; plastic parts are fed by vibrating plate, and use a one-out four-feeding and unloading mode, and plastic parts take-up module once Take four plastic parts and put them on the assembly platform; the double-sided tape with the sponge is sent to the stripping platform, and then removed by the foam back glue transplanting mechanism and moved to the assembly position of the plastic parts, and the foam suction mechanism pre-presses the sponge to the surface. On the plastic part; the sponge suction mechanism returns to the foam area of the feeder to absorb the foam, move and pre-press the sponge to the plastic part on station 2; perform a reciprocating cycle.

Technical parameter

1. The product parts are supplied by the vibrating plate

2. Assembly efficiency is 3200PCS/H

3. Equipment repeatability ±0.15mm

4. Mounting accuracy ±0.3mm

Process flow description:

1. The adhesive is supplied in rolls and fed through Feida;

2. The sponge is supplied by the vibrating plate;

3. After the sponge is in place, the feeding manipulator absorbs and sticks it to the double-sided adhesive position on the feeder. After the sponge is attached, the feeder pulls the bottom paper foam to move forward. The upper part of the middle feeder is designed with a pressure-maintaining sponge mechanism to ensure that the sponge can Stick firmly to the double-sided tape; after the sponge and the double-sided tape are pressed together, Feida sends the sponge with the double-sided tape to the peeling platform

4. The plastic parts are supplied by a vibrating plate, and the loading and unloading mode of one out of four is used. The plastic parts reclaiming module takes four plastic parts at a time and places them on the assembly platform;

5. After the double-sided tape pasted on the sponge is sent to the peeling platform, it is removed by the foam back glue transplanting mechanism and moved to the assembly position of the plastic part, and the foam suction mechanism pre-presses the sponge on the plastic part;

6. After the foam is pre-pressed to the plastic parts, the plastic parts platform moves to the pressure-holding station 1. After the pressure-holding mechanism is in place, the pressure-holding mechanism goes down to maintain the pressure. middle;

7. In the fifth step, the sponge suction mechanism returns to the foam area of the feeder to absorb the foam, move and pre-press the sponge to the plastic parts on station 2, and perform a reciprocating cycle.

1. The product parts are supplied by the vibrating plate

2. Assembly efficiency is 3200PCS/H

3. Equipment repeatability ±0.15mm

4. Mounting accuracy ±0.3mm

/